Design proposal

Three-stone oval, vine shoulders

2 ct oval lab-grown diamond centre, two round side diamonds, yellow gold on a 2 mm band with a fine floral vine engraved along the outside of the shank. Two side-stone sizes for comparison.

Option A · Angled
Drag to rotate · pinch to zoom

Side by side

Option AOption B
Centre2.00 ct oval · approx. 9.7 × 6.6 mm · north–south
Side stones2 × 0.50 ct round2 × 0.33 ct round
Side diameter≈ 5.1 mm≈ 4.4 mm
Total diamond weight3.00 ct2.66 ct
Side ÷ centre width77%67%
Spread across the finger≈ 18 mm≈ 16.5 mm
How it readsA full, even row. The sides act almost as partners to the oval.The oval clearly leads. Slimmer profile that suits the 2 mm band.

Every view, A against B

Frontthrough the finger opening

Rendering…
A · 0.50 ct sides
Rendering…
B · 0.33 ct sides

Sideprofile, setting height and shank

Rendering…
A · 0.50 ct sides
Rendering…
B · 0.33 ct sides

Angledthree-quarter, shows the floral engraving

Rendering…
A · 0.50 ct sides
Rendering…
B · 0.33 ct sides

Face-upas seen on the hand

Rendering…
A · 0.50 ct sides
Rendering…
B · 0.33 ct sides

Setting choices

Centre: four rounded claws

Claws sit toward the oval's ends, clear of the side stones, so the full face of the oval shows. A six-claw head is an option if extra security is preferred.

Sides: four claws each

Individual baskets, set slightly lower than the centre and tilted with the curve of the band so all three stones read as one line.

Cathedral shoulders

Claws taper down into the 2 mm shank, which keeps the band slim at the back while giving the stones a secure base.

Floral vine engraving

A fine stem with small leaves and three little five-petal flowers, engraved along the outside of the shank on both sides, below the stones. No accent diamonds, so it stays delicate.

Concept render for proportion review, modelled at approximately ring size 6.5. Stone dimensions are typical for these weights; final CAD will be built to the actual stones and the final finger size.